I have 3 LNBs connected through DiSEqC 1.0 switch:
input 1: Astra 28,2
input 2: Astra 23,5
input 3: Astra 19,2
Although using AverTV software I can access any satellite, in SmartDVB only the LNB connected to input 1. The reason is, with SmartDVB no DISEqC messages outcome from the card, even with proper (hopefully) LNB setup. I have confirmed using DiSEqC monitor tool that really no DiSEqC is transmitted in the coax.
Is this a lack of support for AverMedia card, or am I doing something wrong?
I am using AverMedia PCI hybrid DVB-S card (A706), SmartDVB 0.2.5.1, Florian BDA, see also attached logs capturing an attempt of tuning a transponder from LNB3.
Thank you much